It the stain has dried, you may be able to remove larger chunks with a blunt knife, but be careful not to damage the carpet fibres.

When you’ve covered the whole area, let the washing up liquid sit in the carpet for 3-5 minutes, before blotting it up with a different dry cloth (make sure it’s white).Always blot a carpet rather than rub to prevent damage.. To get rid of any remaining solution and dirt, give the area a rinse with cold water and blot it dry again with a different cloth.

Then allow the area to fully air dry before covering it..Finally, when the patch of carpet is completely dry, give it another vacuum..You can also use a commercial carpet cleaning product for this method.

These are more expensive than using washing up liquid though – and.may not be any more effective.

Clean Dirt With White Vinegar.

White vinegar is another DIY cleaning product that you can.Use a soft, dry cloth to wipe down the inside to remove any loose debris.

Do not use water for this.. You should also check the air outlet in the floorhead for any blockages or clogging.Even a partial blockage here will reduce airflow, leading to reduced suction power..

Step 5: Re-Fit The Brush Bar.The final step is to replace the brush bar inside the floorhead.